电动捆钞机使用说明
一．前言
本公司引进国外先进技术和设备，开发研制了微电脑捆钞机。经过多年不断地改进完善，使其达到了结构合理，使用方便，经久耐用，造型美观的地步，具有其它类型捆钞机无可比拟的优势，因而赢得了金融界的信赖，现已出口到东南亚多个国家。
二．本机特点
适用于成把纸币的捆钞，本机能全自动控制扎紧度。只需按上升压币键，初捆钞票压紧，能自动停机，如要增压，再按一次（空机时也能自动停机）。触按下降键，能自动复位。不会产生误动作，增加了安全系数，及延长使用寿命等会特点，大大提高了工资率，深受金融界人士的欢迎和信赖。
三．使用说明
1.接通220伏电源，开启后面电源开关，面板电源指示灯亮。
2.按下降松币键托钞板下降复位。
3.翻开活动爪，把捆钞绳放在托钞板糟内。
4.将钞票放在纸币室内，合上活动爪。
5.按上升压币键，压紧钞票，自动停机。如要增压，重按上升。
6.按下降键，复位时自动停机然后取票。
四．注意事项
被压钞票紧时，若遇停电，或其他原因，造成托钞板无法下降，可用内六角扳动后面的固定螺帽，已使机子复位，取出被压钞票。
Direction For Use
A. Preface
Our company introduced advance technology and equipment from other countires, and researched to develop the microcomputer bank note bunding machine. A ter many years of countires improvement , it now arrives at the point that it has more rational struvyure, handsome sculpt, convenient use, and durable life. So it possesses unexampled advantages compared with other types, and wins financial trust, and now is exported to several countries of Southeast Asia.
B. Characteristics
Suitable to bundle bank notes, this machine may control the tightness of binding. Only by pressing down the Raising Button, as the notes to be bundled getting tightened, the machine may shop automatically. If more pressure needed, press it down again. When no loads found , the machine stops automatically too. Pressing Lowering Button means automatic resent. No malfunctions occur, the safety factor increases, and use life prolongs. Since the working efficiency is carried to a higher level, it is deeply welcomed and trusted by financial presonages.
C. Directions
a.Connecting to the 220 volts power supply,any Pressing on the switch backside , the indicator on the Panel gets light.
b. Press down the Lowering Button to reset the note Holding plate .
c. Turn over the movable claw . And put bunding rope Inside the groove of the plate.
d. Put the notes into the paper note room, and turn on the claw.
e. Touch the Raising Button to paper the notes. Then the Machine stops automatically .If higher pressure needed press it again.
D. Notice
If the notes pressed tightly, power cut encountered . or because of other reasons so as to note holding plate getting unable to lay down , you may rotate clocking the screw located backside by a hexangular spanner to reset the machine for the withdraw of the pressed notes.